SMC Networks SMCD3GN-RRR User Manual page 13

C C o o n n f f i i g g u u r r i i n n g g W W i i r r e e l l e e s s s s S S e e c c u u r r i i t t y y
The front panel has a WPS button for configuring wireless security automatically. Pressing
this button for 5 seconds automatically configures wireless security. If the client device
supports WPS Push Button Configuration (PBC), press the button within 60 seconds to
automatically configure security on the client.
After pressing this button for 5 seconds, the WPS LED on the front panel flashes. When a
client joins the network successfully, the LED remains ON until the next WPS action or the
device reboots. If no client joins, the LED stops blinking after 4 minutes.
R R e e a a r r P P a a n n e e l l
The rear panel of your SMCD3GN-RRR Wireless Cable Modem Gateway contains a reset
button and the ports for attaching the supplied power adapter and making additional
connections. Figure 2 shows the rear panel components and Table 2 describes their
meanings.
!
Figure 2. Rear View of your SMCD3GN-RRR Wireless Cable Modem Gateway
Table 2. SMCD3GN-RRR Wireless Cable Modem Gateway Rear Panel Components
Item
Power (12VDC)
!
" LAN 1-4
# USB
$ Cable
% Reset button
SMCD3GN-RRR Wireless Cable Modem Gateway User Manual
Getting to Know Your Gateway
"
Connect the supplied power cord to this port.
Four 10/100/1000 auto-sensing RJ-45 switch ports. Connect devices on your local area network
such as a computer, hub, or switch to these ports.
USB 2.0 high-speed port for storing configurations externally.
Connect your coaxial cable line to this port.
Use this button to reset the power or restore the default factory settings (see "Restoring Factory
Defaults," below). This button is recessed to prevent accidental resets of your Gateway.
13
$
#
Description
%