Replacing Saw Chain; Storage; Replacement Parts And Accessories; Repair Service - Remington RM1215U Owner's Manual

REPLACING SAW CHAIN

Replace chain when cutters are too worn to sharpen or
when chain breaks. Only use replacement chain noted in
this manual. Always include new drive sprocket when
replacing chain. This will maintain proper driving of
chain. Note: For proper chain and drive sprocket,
see Replacement Parts and Accessories.

STORAGE

If storing saw for more than 30 days, follow steps below.
1. Drain oil tank.
2. Remove and clean guide bar and chain. Clean
guide bar and chain by soaking in petroleum
based solvent or mild soap and water mixture.
3. Dry guide bar and chain.
4. Place chain in container filled with oil. This will
prevent rust.
5. Wipe a thin coating of oil over surface of guide bar.
6. Wipe off outside of saw body. Do this with soft cloth
dampened with a mild soap and water mixture.
7. Store chain saw
• in a high or locked place, out of children's reach
• in a dry place
• in a carrying case or with scabbard over guide bar
REPLACEMENT PARTS AND
ACCESSORIES
WARNING: Use only replacement
parts and accessories described in this
manual. Use of other parts or accessories
could damage saw or injure operator.
For original replacement parts and accessories, call
1-866-206-2707 (in Canada call 1-877-696-5533)
or visit www.remingtonpowertools.com.

REPAIR SERVICE

Note: Only use original replacement parts. This will
protect your warranty coverage for parts replaced
under warranty.
For service, please call the Customer Support
Department to obtain a list of authorized service
dealers near you. Service on this unit, both within
and after the warranty period, should only be
performed by an authorized and approved service
dealer.
Call 1-866-206-2707 (in Canada call 1-877-696-
5533) or visit www.remingtonpowertools.com.
16