Table of Contents
Advertisement
The torque (drag) of the Main Tuning Dial knob may be adjusted according to your
preferences. Simply hold down the rear skirt of the knob, and while holding it in place
rotate the knob itself to the right to reduce the drag or to the left to increase the drag.
Available adjustment range is 120°.
Resetting the Microprocessor
Resetting Memories (Only)
Use this procedure to reset (clear out) the Memory channels previously stored, without
affecting any configuration changes you may have made to the Menu settings.
1.
Press the front panel's [POWER] switch to turn the transceiver off.
2.
Press and hold in the [A>M] button; while holding it in, press and hold in the front
panel's [POWER] switch to turn the transceiver on. Once the transceiver comes on,
you may release the [A>M] button.
Menu Resetting
Use this procedure to restore the Menu settings to their factory defaults, without
affecting the memories you have programmed.
1.
Press the front panel's [POWER] switch to turn the transceiver off.
2.
Press and hold in the [MENU] button; while holding it in, press and hold in the
front panel's [POWER] switch to turn the transceiver on. Once the transceiver
comes on, you may release the [MENU] button.
Full Reset
Use this procedure to restore all Menu, Memory settings, and Tuner Memory settings
to their original factory defaults. All Memories will be cleared out by this procedure.
1.
Press the front panel's [POWER] switch to turn the transceiver off.
2.
Press and hold in the [FAST] and [LOCK] buttons; while holding them in, press
and hold in the front panel's [POWER] switch to turn the transceiver on. Once the
transceiver comes on, you may release the other two switches.
Important Note: When the optional µTuning Kit is connected to the FT-950, disconnect
the all cables from the µTuning Kit then perform the Full Reset.
Antenna Considerations
The FT-950 is designed for use with any antenna system providing a 50 Ohm resistive
Installation and Interconnections
10
FT-950
Operating Manual
Vertex Standard Co., Ltd.
Advertisement
Table of Contents
