Standard Horizon HX751 Owner's Manual page 37

04 tEP ( TEMP ADJUST )
Function: Calibrating the Thermometer setting
Available Values: –9.9 ~ +9.9
Default: 0.0
See page 31 for details.
05 LP ( LAMP MODE )
Function: Selects the Lamp illumination method for the LCD/
Keypad.
Available Values: Cnt / kEY / off
Default: kEY
kEY: Illuminates the LCD/Keypad for 5 seconds when any key is pressed.
Cnt: When turning on the radio, the LCD/keypad lamp is illuminated continously.
Pressing the [ LIGHT ( STROBE )] key toggles the LCD/Keypad lamp On/
Off.
Off: When turning on the radio, the LCD/keypad lamp is not illuminated. Press-
ing the [ LIGHT ( STROBE )] key toggles the LCD/Keypad lamp On/Off.
06 dr ( DIMMER )
Function: Adjusting of the display brightness
Available Values: 00 / 01 / 02 / 03
Default: 02
07 SnL ( SCAN LAMP )
Function: Enable/Disable the automatic illumination of the lamp
when a signal is received on a channel during scanning
Available Values: on / oFF
Default: oFF
08 SCn ( SCAN DISPLAY )
Function: Selects the Scanning display mode
Available Values: nor (Normal) / SPL (Special)
Default: nor (Normal)
When this menu is set to "nor (Normal)", the channel numbers during scan will
be shown as scrolling on the display. When "SPL (Special)" is selected the
channel numbers on the display do not change unless a call was received.
The channel shown is the last channel that was received.
09 dt ( DUAL WATCH MODE )
Function: Selects dual or tri-watch as desired.
Available Values: d- (Dual Watch) / t- (Triple Watch)
Default: d- (Dual Watch)
See page 27 for details.
HX751 Page 37