Preset Channels 0 ~ 9 : Instant Access - Standard Horizon HX751 Owner's Manual

6.9 PRESET CHANNELS 0 ~ 9 : INSTANT ACCESS

Ten user assigned channels can be programmed for instant access. Pressing
the [ PRESET ] key activates the user assigned channel bank. If the [ PRESET ]
key is pressed and no channels have been assigned, an alert beep will be
emitted from the speaker.
6.9.1 PROGRAMMING
1. Press the [ ] or [ ] key (repeatedly, if necessary) until the desired chan-
nel number is displayed.
2. With the desired channel number displayed, Press and
hold the [ PRESET ] key. The indication of "PRESET" and
the Preset Channel number "0" will appear at the right of
the channel number on the display for 1 second.
3. Repeat steps 1 and 2 to program the desired channels into Preset Chan-
nels "1" ~ "9".
4. To delete a Preset Channel, press the [ PRESET ] key until the Preset Chan-
nel number to be deleted is displayed, then press and hold the [ PRESET ]
key.
Weather channels can be stored as preset for quick selection. To save a
Weather channel in Preset memory, press and hold the [ CLR ( WX )] key
to enter Weather channel mode then perform the steps in 6.9.1 above.
6.9.2 OPERATION
Pressing the [ PRESET ] key will toggle between Preset Channels "0" through
"9". The indication of "PRESET" and the Preset Channel "0"
are represented by "0" to the right of the channel number on
the display for 1 second, and preset channel "1" is repre-
sented by "1" and so forth. The preset channel number will
disappear after 1 second ("PRESET" is displayed during the PRESET opera-
tion, and not shown when the preset mode is exited).
To exit from the preset channel mode, press the [ CLR ( WX )] key or press the
[ ] / [ ] key.
6.9.3 PRESET CHANNEL SCAN
After channels have been stored into preset memory, the channels may be
scanned by following the steps below:
1. To start scanning, press the [ SCAN ( DW )] key.
2. To stop the scan, press the [ SCAN ( DW )] or [ CLR ( WX )] key.
Page 26
NOTE
HX751