Standard Horizon HX751 Owner's Manual page 29

8. Repeat steps 6 and 7 for all the channels to be scanned.
9. To delete a channel from the transceiver's scan memory, select the memo-
rized channel, then press the [ CLR ( WX )] key. The "on" indication changes
to "oFF".
10. Press the [ SQL ] key to save the new setting, then press the PTT switch to
exit to normal operation.
11. All channels programmed remain in the transceiver's scan memory even if
the power is turned off.
6.10.2 OPERATION
1. Adjust the SQL level until background noise is eliminated by pressing the
[ SQL ] key followed by the [ ] / [ ] key.
2. To start scanning, press the [ SCAN ( DW )] key. The scan proceeds from the
lowest to the highest programmed channel and stops
scanning when a transmission is received. Scanning will
resume when the incoming signal disappears at the end
of the transmission. A blinking "SCN" icon will appear at
the left bottom of the display during scanning.
3. To stop the scan, press the [ SCAN ( DW )] or [ CLR ( WX )] key.
Memory scan starts from the lowest to the highest channel pro-
grammed into memory.
When an incoming signal is detected on one of the channels during
scan, the radio will pause on that channel, allowing you to listen to
the incoming transmission.
When the transmission stops the radio will automatically start scan
again.
During Memory Scan, the channels will rapidly change and a "SCN"
icon will be shown in the left bottom of the display.
HX751
CH01A
CH88A
CH68A
CH68A
CH61A
CH22A
M
NOTE
CH09
CH12
CH15
CH18
S
Page 29