Troubleshooting Guide - U-Line CLR2160 Use And Care Manual

Troubleshooting Guide

DANGER
ELECTROCUTION HAZARD
Never attempt to repair or perform maintenance on
the unit until the main electrical power has been
disconnected.
Troubleshooting - What to check when problems occur:
PROBLEM
Unit does not operate and
electronic display is blank.
No interior light (Model CLRCO2175) No power to unit
Electronic display is blank and
interior light is ON with door OPEN
(Model CLRCO2175).
Electronic display is blank with door
OPEN (Model CLR2160).
Electronic display shows repeating,
randomly flashing symbols and
partial characters.
Electronic display shows:
0, 1 to 26, or 99.
Electronic display shows E3.
Electronic display shows one or
more of the following:
E1, E2, E4, E5, E6, E7, E8, E9, E10, P1.
The unit is not cold enough.
Noise during operation
Fresh food section too cold (Model
CLRCO2175)
Unit runs but no ice is produced.
POSSIBLE CAUSE
No electrical supply
Low air temperature around unit
Loose or burned out bulb
A display function has changed.
A display function has changed.
A factory control mode has been
inadvertently entered.
A factory control mode has been
inadvertently entered.
Door has been left open longer than
20 minutes.
The unit is displaying an error code.
Dirty condenser coils
Airflow to front grille blocked
Temperature not set cold enough
(Model CLRCO2175)
Door is not closing completely.
Door gasket not sealing properly
Certain sounds are normal.
Temperature control set too cold
No water being supplied to the unit
CLR2160, CLRCO2175
NOTE: Recommended refrigerator temperature setting is
38°F.
REMEDY
Plug unit in or check circuit breaker.
Surrounding air temperature must be at least 50°F.
Make sure power cord is plugged in.
Tighten or replace bulb (See MAINTENANCE; LIGHT
BULB REPLACEMENT).
Touch and hold the warmer temperature button and
touch and release the POWER button three times, then
release the temperature button. The display should
become visible.
Touch and hold the warmer temperature button and
touch and release the POWER button three times, then
release the temperature button. The display should
become visible.
Touch and hold the warmer temperature button and
touch and release the LIGHT button three times, then
release the temperature button to exit the factory
control mode. The set-point temperature should now
be displayed.
Repeatedly touch the warmer temperature button to
advance any number shown to 99 and touch and
release the LIGHT button. The set-point temperature
should now be displayed.
Close door completely. The set-point temperature
should now be displayed.
Record the error code(s) displayed and call for service.
Clean condenser (See MAINTENANCE; CONDENSER
CLEANING).
Airflow must not be obstructed to front grille (See
OPERATION).
Use the temperature controller to set temperature
colder. Allow 24 hours for temperature to stabilize.
Make sure no obstructions are blocking the door and
unit is level (See MAINTENANCE; LEVELING).
Door adjustment required (See MAINTENANCE; DOOR
ALIGNMENT CHECK AND ADJUSTMENT).
Adjust door (See MAINTENANCE; DOOR ALIGNMENT
CHECK AND ADJUSTMENT and DOOR REVERSAL).
Soft sounds from the fan, water running in the ice
maker and the sound of ice dropping will be heard.
Use the temperature controller to set temperature
warmer.
Check to see that water is connected and turned on to
the unit.
25