Op(36,42)Fp32 Lighting Instructions - Empire Comfort Systems OP36FP32MN-2 Owner's Manual

Op(36,42)Fp32 LIGHTING INSTRUCTIONS

FOR YOUR SAFETY READ BEFORE LIGHTING
WARNING: If you do not follow these instructions exactly, a fire or explosion may result
A. This appliance has a pilot which must be lighted by
hand. When lighting the pilot, follow these instructions
exactly.
B. BEFORE LIGHTING smell all around the appliance area
for gas. Be sure to smell next to the floor because some
gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electrical switch;
Do not use any phone in your building.
• Immediately call your gas supplier from a neighbor's
phone. Follow the gas supplier's instructions.
• If you cannot reach your gas supplier, call the fire
department.
• Any glass doors shall be opened when the appliance is in operation.
• A fireplace screen must be in place when the appliance is operating and, unless other provisions for combustion air
are provided, the screen shall have an opening(s) for introduction of combustion air.
1. STOP! Read the safety information
above.
2. Set the ON/OFF switch to "OFF."
3. Turn off all electric power to the appli-
ance (if applicable).
4. Push in gas control knob slightly and
turn clockwise
5. Wait ten (10) minutes to clear out any
gas. Then smell for gas, including near
the floor. If you smell gas, STOP! follow
"B" in the safety information above. If
you do not smell gas, go to the next step.
NOTE: Knob cannot be turned from "PI-
LOT" to "OFF" unless knob is pushed in
slightly. Do not force.
6. Find pilot - follow metal tube from gas
control. The pilot is in front of the middle
log on the right side.
7. Turn gas control knob counterclockwise
to "PILOT."
1. Set the ON/OFF switch to "OFF".
2. push in gas control knob slightly and turn clockwise
to "OFF". Do not force.
32272-0-0713
causing property damage, personal injury or loss of life.
LIGHTING INSTRUCTIONS
GAS CONTROL
KNOB SHOWN IN
"OFF" pOSITION.
to "OFF."
TO TURN OFF GAS TO AppLIANCE
C. Use only your hand to push in or turn the gas control
knob. Never use tools. If the knob will not push in or
turn by hand, don't try to repair it; call a qualified ser-
vice technician. Force or attempted repair may result
in a fire or explosion.
D. Do not use this appliance if any part has been under
water. Immediately call a qualified service technician
to inspect the appliance and to replace any part of the
control system and any gas control which has been
under water.
WARNING
8. Push in control knob all the way and hold in. Immediately
light the pilot with a match and lighter rod that is provided
with the burner. Continue to hold the control knob in for
about one (1) minute after the pilot is lit. Release knob, and it
will pop back up. Pilot should remain lit. If it goes out, repeat
steps 4 through 8.
If knob does not pop up when released, stop and immediately
call a qualified service technician or gas supplier.
If the pilot will not stay lit after several tries, turn the gas con-
trol knob to "OFF" and call your service technician or gas
supplier.
9. Turn gas control knob counter clockwise
"ON."
10. Set the ON/OFF switch to "ON."
to
Page 15