Arming When Leaving - NAPCO FREEDOM Manual

If you are leaving with no other family members remaining home:
1
READY
2
AWAY
ARMED
3
4
6
A R M I N G W H E N L E AV I N G
Check the F-TP Touchpad indicators. The green
that the system is ready to arm.
•
If the green READY light is BLINKING, this indicates that a zone is faulted. The READY light is blinking out the zone
number of the open zone. Count the flashes and look at your zone list to see which zone is open and secure it (close
the door or window, etc.). If you cannot immediately secure the zone, it may be bypassed (see page 7).
•
If the green READY light is OFF, another monitored deadbolt is not locked. All other monitored deadbolts must be
locked before the system can be armed. Go to the other deadbolt location and lock it.
Press the AWAY button.
If you change your mind after pressing AWAY, press SILENCE to clear arming.
The ARMED indicator will begin to flash, indicating the 60 second exit delay period.
Open the door and exit.
Lock the deadbolt from the outside to arm the system. The F-TP Touchpad will give one chirp to
indicate the system has armed.
If the deadbolt has not been locked within 60 seconds of pressing AWAY, the system will revert
back to a disarmed state.
If the system detects movement inside the premises within 60 seconds of arming, it will automati-
cally revert to Stay mode, providing perimeter protection with the interior protection (motion sen-
sors) turned off. (See ARMING WHEN STAYING HOME - page 8).
light should be ON-STEADY, indicating
READY