7. Lock the Speed Control Arm in place by
tightening the two lock nuts.
8. Repeat procedure for other side of unit.
9. Reinstall side shrouds.
Eccentric
Speed Control Arm
Locknuts and Bolts
Flange Bushing
Locknuts and Bolts
OE0082
ADJUSTING THE UNIT TO TRACK
STRAIGHT
The primary reason the unit may not track straight is
incorrect or unbalanced tire air pressure. First, check
and adjust tire pressure. Increase pressure on the side
the unit tracks toward. DO NOT exceed maximum
recommended tire pressure. See Specifications .
If adjusting tire air pressure does not the solve tracking
problem the steering control lever travel may need to
be adjusted.
To check steering control levers:
With the engine off, push the steering control levers to
their full forward position. If one lever travels farther
than the other, they need to be adjusted.
To adjust:
1. Remove side shrouds. Set aside.
2. Loosen bolts which attach the eccentric to the
seat support. Do not remove the bolts.
3. Rotate eccentric to adjust the travel of the speed
control arm. The thicker portion of the eccentric
shortens the distance the steering control lever
will travel forward. The thinner portion of the
eccentric lengthens the distance the steering
control lever will travel forward.
3
1
2
3
2
1
OE0850
Longer Travel
Shorter Travel
1. Eccentric
3. Speed Control Arm
2. Bolt
Page 27