Headlight Aiming Adjustment - Hyundai i10 Owner's Manual

Maintenance
G220104APA-UK
Before performing aiming adjustment,
make sure of the following.
1. Keep all tyres inflated to the correct
pressure.
2. Place the vehicle on level ground and
press the front bumper and rear
bumper down several times. Place the
vehicle at a distance of 118 in. (3,000
mm) from the test wall.
3. See that the vehicle is unloaded
(except for full levels of coolant, engine
oil and fuel, and spare tyre, jack, and
tools).
Have the driver or equivalent weight
placed in driver's seat.
4. Clean the head lights lenses and turn
on the headlight (low beam).
7 52
Horizontal aiming
Vertical aiming
5. Open the bonnet.
6. Draw the vertical line (through the cen-
tre of each headlight beam pattern)
and the horizontal line (through the
centre of each headlight beam pattern)
on the aiming screen.
And then, draw a horizontal parallel
line at 1.18 in. (30 mm) under the hori-
zontal line.
7. Adjust each cut-off line of the low
beam to the parallel line with a phillips
screwdriver - VERTICAL AIMING.
8. Adjust each cut-off line of the low
beam to each vertical line with a
phillips screwdriver - HORIZONTAL
AIMING.
Horizontal line
H
OPA077034
Adjustment after headlight assembly
replacement
If the vehicle has had front body repair
and the headlight assembly has been
replaced, an headlight aiming should be
checked using an aiming screen as
shown in the illustration. Turn on the
headlight switch. (Low Beam Position)
1. Adjust headlights so that main axis of
light is parallel to centre line of the
body and is aligned with point "P"
shown in the illustration.
2. Dotted lines in the illustration show the
centre of headlights.
Vertical line
W
P
H
Cut-off line
Ground line
L
G290B01TG-R