Hyundai i10 Owner's Manual page 140

Features of your vehicle
NEWS >
RDS TA Vol >
Return
Adjust >
Display >
Clock
Update >
Return
Scroll > On
Return
❈ TO SETUP CLOCK
If Audio is ON
1. Press SETUP button.
2. Select CLOCK menu by rotating/pressing
TUNE knob.
3. Select ADJUST and current hour will
flash.
4. Adjust hour by rotating TUNE knob.
5. Press TUNE knob and now current
minute will flash.
6. Adjust minute and push TUNE knob
when finished.
7. Press SETUP button or select RETURN
to exit SETUP mode.
4 76
If Audio is OFF
Off
1. Press SETUP button and current hour
+05
will flash.
2. Adjust hour and press TUNE knob.
3. Rotate TUNE knob to adjust minute
when the current minute is flashing.
24Hour
4. Push TUNE knob, and press SETUP
Auto
button or select RETURN to exit
SETUP mode.
11. TUNE/ENTER Knob
Turn this knob clockwise by one notch to
increase frequency by 0.05Mhz from cur-
rent frequency.
Turn this knob counterclockwise by one
notch to decrease frequency by 0.05Mhz
from current frequency.
Press this knob whilst holding SETUP
button to activate / inactivate the
item.Select SETUP item using left and
right function of the Tune knob.
GENERAL FM 100kHz
AM
EUROPE FM
MW
LW
USA FM 200kHz
AM
12. PTY(FLDR) Button
• Press this button to enter Program Type
select mode.
• Press Move[PTY
rotate TUNE knob when to search
Program Type in RDS.
• Press TUNE/ENTER knob to select
Program Type, and program search will
be started from the current frequency.
13. PRESET Button
Push [1]~[6] buttons less than 0.8 sec to
play the channel saved in each button.
Push PRESET button for 0.8 sec or longer
to save current channel to the respective
button with a beep.
14. SCAN Button
If the SCAN button is pressed during
receiving the broadcast for 5 sec, if can-
cels SCAN operation and receives the
broadcast flickering at that time.
When inputting SCAN KEY during
receiving the broadcast for 5 sec cancel
9kHz
the operation of SCAN and receive the
50kHz
broadcast flickering at that time.
9kHz
In case of no input for cancel after
inputting SCAN KEY, operate SCAN only
1kHz, 3kHz(AUTO)
1CYCLE.
10kHz
. ] button or