Hyundai i10 Owner's Manual page 146

Features of your vehicle
Adjust >
Clock Display >
Return
Scroll > On
Return
❈ TO SETUP CLOCK
If Audio is ON
1. Press SETUP button.
2. Select CLOCK menu by rotating/pressing
TUNE knob.
3. Select ADJUST and current hour will
flash.
4. Adjust hour by rotating TUNE knob.
5. Press TUNE knob and now current
minute will flash.
6. Adjust minute and push TUNE knob
when finished.
7. Press SETUP button or select RETURN
to exit SETUP mode.
If Audio is OFF
1. Press SETUP button and current hour
will flash.
2. Adjust hour and press TUNE knob.
3. Rotate TUNE knob to adjust minute
when the current minute is flashing.
4. Push TUNE knob, and press SETUP
button or select RETURN to exit
SETUP mode.
4 82
10. TUNE/ENTER Knob
Turn this knob clockwise by one notch to
24Hour
increase frequency by 0.05Mhz from cur-
rent frequency.
Turn this knob counterclockwise by one
notch to decrease
100kHz(0.05Mhz) from current frequency.
Press this knob whilst holding SETUP
button to activate / inactivate the item.
Select SETUP item using left and right
function of the Tune knob.
(0.05Mhz) is A-200PAS only.
GENERAL FM 100kHz
AM
EUROPE FM
MW
LW
USA FM 200kHz
AM
11. PRESET Button
Push [1]~[6] buttons less than 0.8 sec to
play the channel saved in each button.
Push PRESET button for 0.8 sec or longer
to save current channel to the respective
frequency by button with a beep.
12. SCAN Button
If the SCAN button is pressed during
receiving the broadcast for 5 sec, if can-
cels SCAN operation and receives the
broadcast flickering at that time.
When inputting SCAN KEY during
receiving the broadcast for 5 sec cancel
the operation of SCAN and receive the
9kHz
broadcast flickering at that time.
50kHz
In case of no input for cancel after
inputting SCAN KEY, operate SCAN only
9kHz
1CYCLE.
1kHz, 3kHz(AUTO)
10kHz