Creda 70305S Assembly Instruction Manual page 7

ENSURE THAT CABLE CLAMP
IS SECURELY ATTACHED TO
THE CHASSIS OF THE HEATER.
5
Place the heater on its feet, and in the desired
position against the wall - DO NOT LIFT THE
HEATER BY ITS TOP PANEL! Ensure that
the heater is based on a firm level surface,
at least 100mm from any end wall, and at least 100mm
below any shelf or similar projection. Cut away the gripper
rod or carpet which would prevent the heater sitting firmly
on the floor.
6
Mark the position of the two outside corners of the wall
bracket with the heater pushed tight against the wall.
Remove the wall bracket from the heater by removing
the screw at each end. Place the heater to one side
and reposition the bracket against the wall using the corner marks for
alignment.
Four fixing positions must be chosen for the SFH24AW and three for
the SFH18AW. Mark the positions for the fixing holes - two at extreme
ends and the others spaced evenly between them. Remove the bracket
from the wall, drill the holes in the positions marked, and insert suitable
fixings previously described. Secure the wall bracket to the wall using
the correct fasteners.
Ensure that any slack is pulled back through each clamp and
tighten the clamping screws. Make sure clamp is tightening
on outer sheath of cable and not on individual conductors.
Secure cables to base of heater using ties provided in fixing
kit.
4