Creda 70305S Assembly Instruction Manual page 4

PLEASE DON'T TAKE CHANCES
Site conditions may vary considerably and Creda cannot recommend the correct wall fixings to be used. It is the responsibility of
the installer to ensure that adequate permanent fixing has been achieved. Purely for guidance the suggested fixings are made for
certain wall materials but this list is not comprehensive or authoritative. Different wall constructions will need different inserts. Note
that inserts incorporating plastic may be subject to shrinkage behind a warm storage heater and are therefore not recommended.
Wall fixings can be obtained from local stockists
CARPETS: For safety, the heater must be positioned in the room so that there is at least 75mm free air space all around it; under
windows, ensure that curtains, when drawn, cannot touch or cover the heater casing. In order to maintain stability, it is essential
that the heater be placed on a level surface and care should be taken to avoid irregular surfaces, such as may result from carpets or
tiled surrounds partially protruding under the heater. The heater feet are designed to go underneath a carpet rather than standing
on it; this permits the weight to be taken on a firm base. Carpet gripper should be removed from behind the heater feet.
BRICKS: The heater casing and the heater storage bricks with which it must be fitted, are delivered in separate packages. The
brick is common to all heaters, packed in pairs.
The brick catalogue number is 791402015. 70305S models have 12 bricks. 70315S have 16 bricks.