Table of Contents
Advertisement
STRYKER CVAHU
CONFIGURATION
BY ZIO WALL
MODULE
Figure 4: Stryker CVAHU configuration by Zio wall
module
Strykers are configured by the new TR71/75 wall
modules. Nearly every configuration parameter is
available at the Zio wall module, so configuration and
even balancing is done by simply powering up the
controller, connecting a Zio and then configuring the
parameters available. After configuration is done via
the Zio, an Integrator perform an upload and the
configuration is added to the WEBs-AX station
database.
Since Stryker has the capability to utilize Zio, an
installer uses a conventional sensor on all installed
Stryker units, and then uses a single Zio to configure
as many Stryker's as desired. Since the Zio's program
and configuration are stored in the Stryker, each time
the Zio is connected to a new Stryker, it gets its
program from that device.
This document serves as a configuration guide for an
installer who is configuring a Stryker CVAHU
controller via a TR71 or TR75 wall module.
Parameters are grouped into logical categories rather
than on a large list. To access the "contractor" mode
for configuration, press the up, down and middle keys
simultaneously. During this time the model number
and firmware revision of the TR71/75 are displayed.
You are then prompted to enter a password (default
0000).
STRYKER CVAHU ZIO CONFIGURATION GUIDE
Compatibility
The TR70 Series LCD Wall Modules operate with the
Sylk Enhanced Stryker controller. The TR71/TR75
can replace a TR70 in an installation where an
upgrade to WEBs- AX or Stryker or reprogramming is
not desired. Features like scheduling, additional
memory, etc. are not available. Likewise, a TR71 is
replaced by another TR71 or TR75 without
reprogramming required. A TR75 can only be
replaced with a TR75 where no reprogramming is
desired.
Contractor Mode:
Introduction
Contractor mode: You can navigate to the desired
category of parameters. You can then begin
configuring and viewing information from the device.
Each screen below has a brief explanation of the
data; values within the contractor mode are only
visiable in English (U.S.) units of measure.
Temperatures however can be shown on the home
screen as C or F.
Contractor mode allows access to the Setup function
of the wall module. To enter and exit the setup
function – press the up and down arrow keys and the
middle soft key all at the same time (see key positions
of wall module as shown in
Figure 5: Key position of wall module
Contractor mode allows advanced options (such as
modifying configured parameters) using the soft keys.
Contractor mode also allows for customizing the
tenant's view including setting the tenant's Home
screen and controlling the tenant's "view more"
access, which can provide the tenant with a view of
the configured parameters.
15
Figure
5).
Hide quick links:
Advertisement
Table of Contents
