Advertisement
3
When bracket is securely fixed, replace
the heater under the bracket angle
and align screw holes on heaters
ends. There are two fixing slots at each end of
heater, allowing different stand-offs for different
thicknesses of skirting board. Do not fully tighten
these screws until the bricks are loaded into the
heater as some settling of the heater may occur.
NOTE : NEVER REMOVE THESE SCREWS
WITHOUT FIRST UNLOADING THE HEATER.
See also figure 1 regarding carpets where
appropriate.
Note: Max. skirting size is 15 x 120mm.
Note that the smallest wall spacing should be used only when the skirting board is of the modern slim type,
or there is no skirting board at all. THE HEATER MUST STAND VERTICAL
4
A clear space of at least 3" (75mm)
must be left at either side of the
heater, and any projections or
shelves must be at least 10"
(250mm) above the heater casing.
Curtains must not be draped around
or in contact with the casing. A
shelf unit is separately available for
fitting above heaters.
The top panel and front panel are joined and should be removed as one assembly. To do this,
WALL FIXINGS - VERY IMPORTANT
remove the screws fixing the rear flange of the top panel, and
remove the two screws along the bottom edge of the front panel.
Carefully swing out bottom of front panel and lift assembly
clear of casing, this operation also removes the control knobs
under the flap. Put assembly in a safe place to avoid damage
to paint etc.
You must fit a
retaining screw at
each end of the
heater.
5
Advertisement
