Advertisement
2
Stand the heater against the wall in its intended position. Mark the position of the two outside
corners of the wall bracket. Carefully place the heater aside, and remove the wall bracket
from the heater by removing the screw at each end. Reposition the bracket against the wall
using the corner marks for alignment. Mark through two slots in the bracket, one at each end.
Allow mortar courses between bricks to be avoided, or battens, etc. to be found for the fixing
holes.
First, turn carton upside down
Open bottom flaps on carton
Packing corner fitments contain heater feet
It is preferable to fit the heater feet whilst the heater is still in its carton.
Turn the carton upside down and open the bottom flaps. The corner
fitments contain both feet and the fixing kit.
The open ends of the feet are to face forward towards the grilles in the
panel. After fitting, use the feet to lift the heater from the carton.
Cut underlay and remove carpet gripper to clear foot, allowing heater
weight to be taken on floor proper; lay carpet over foot, slitting it as
shown, it is unnecessary to cut carpet away.
If mains connection is to be
made from the left hand side, at
this point the mains lead must
be secured to the back of the
heater using ties provided in the
fixing kit.
1
Advertisement
