Rear Panel Description; Iec Socket; Power Switch; Power Indicator - Mackie SRM350v2 User Manual

Active sound reinfocement speaker
Hide thumbs Also See for SRM350v2:
Table of Contents

Advertisement

REAR PANEL DESCRIPTION
The SRM50v has several connectors, controls, and
indicators that you should understand.
1. IEC Socket
This is where you connect the supplied AC linecord to
provide AC power to the SRM50v's built-in power amplifi-
ers. Plug the linecord into an AC socket properly configured
for your particular model.
Note: If you happen to lose the AC linecord, replace-
ments are readily available at any office or computer supply
store. Always use a three-pin plug with a ground pin.
8
2. POWER Switch
EL control is down before you turn it on. Press the bottom
of this switch to put the speaker into standby mode. It will
not function, but the circuits are still live. To remove AC
power, either turn off the AC mains supply, or unplug the
power cord from the speaker and the AC mains supply.
3. POWER Indicator
is connected to an active AC Mains supply, this indicator, lo-
cated just above the POWER switch, glows to let you know
that you're ready to rock and roll. The cool blue LED on the
front of the speaker works in the same way.
POWER
Switch up to turn the SRM50v on. Make sure the LEV-
When the POWER switch is turned on, and the linecord
SIGNAL
LIMIT
NORMAL
+45
O O
+5dB
LEVEL
LINE
100Hz
12k/AIR
MIC
CONTOUR
(+3dB)
THRU
INPUT

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents