Rear Panel Description; Iec Socket; Power Switch; Power Indicator - Mackie SRM350v2 Owner's Manual

REAR PANEL DESCRIPTION

The SRM350v2 has several connectors, controls, and
indicators that you should understand.

1. IEC Socket

This is where you connect the supplied AC linecord to
provide AC power to the SRM350v2's built-in power
amplifiers. Plug the linecord into an AC socket properly
configured for your particular model.
Note: If you happen to lose the AC linecord,
replacements are readily available at any office or
computer supply store. Always use a three-pin plug
with a ground pin.
8

2. POWER Switch

Switch up to turn the SRM350v2 on. Make sure the
LEVEL control is down before you turn it on. Press the
bottom of this switch to put the speaker into standby mode.
It will not function, but the circuits are still live. To remove
AC power, either turn off the AC mains supply, or unplug
the power cord from the speaker and the AC mains supply.

3. POWER Indicator

When the POWER switch is turned on, and the linecord
is connected to an active AC Mains supply, this indicator,
located just above the POWER switch, glows to let you
know that you're ready to rock and roll. The cool blue LED
on the front of the speaker works in the same way.
POWER
SIGNAL
LIMIT
NORMAL
+45
O O
+5dB
LEVEL
LINE
100Hz 12k/AIR
MIC
CONTOUR
(+3dB)
THRU
INPUT