Heat Controller Comfort-Aire BGE-103A Service Manual page 11

6. Remove the backing from the support blocks and
attach them to the inside of the wall sleeve as
shown FIG 13. Slide the baffle into slots of the sup-
port blocks.
Wall
Wall
Sleeve
7.Install the new unit into the wall sleeve.
8.To assemble trim, snap the tab of each piece into the
slot of the other piece as shown below. Slide trim
over the front of the air conditioner until trim is flush
with sleeve as shown below.
Trim (2 ea)
Wall
(
7 5 /
16
Baffle
Front
Support
Block
FIG. 13
Coo
Ene l
rgy Sav er
Fan
Hea
t F2 HIGH F1 LOW
MO Tim er
DE TEM ' F
TIM ER P
FAN
SPE ED
PO WE
R
FIG. 14
• Air conditioners covered in this manual pose an
excessive weight hazard. Two or more people are
needed to move and install the unit.
To prevent injury or strain, use proper lifting and
carrying techniques when moving unit.
)
"
• When handling the air conditioner, be careful to
avoid cuts from sharp metal fins on front and rear
coils.
• Make sure air conditioner does not fall during
removal.
Installation
Service Manual 11