RESTRICTED USE ONLY
4
Replace the Ribbon Cartridge.
a. Press on the Resume button.
b. If the issue persists, continue to Step 5.
5
Press the Cancel Print button on the Driver Monitor Error Display Message.
6
Reboot the Printer by cycling the power.
7
Use the Driver Calibration tab to calibrate the Ribbon Sensor. Cover the front
of the printer to block the light while calibrating this sensor.
•
If the issue persists, continue to Step 8.
8
Replace the Ribbon Sensor.
Resolving a Ribbon Break Jam Error
All Troubleshooting procedures assume that only factory-authorized supplies are in use in
the Printer. (Note: Using the printer in direct sunlight may adversely affect the ribbon sensor
integrity.)
Step
Procedure
1
Review the following information.
•
Symptom: The Print Ribbon has become jammed or has broken in the
Printer.
•
Printer Error State: The Ribbon Supply Encoder Sensor has
unexpectedly stop receiving information from the Ribbon Encoder
•
Driver Monitor Error Display: Ribbon Break/Jam
DTC400e/Persona C30e/M30e Card Printer User Guide (Rev. 1.0)
Fargo Electronics, Inc.
4-21