Operations; Basic Operations - Clarion M502 Owner's Manual & Installation Manual

Optional Wired Remote Control Unit Operations
• PANDORA mode – Station up-down / skip
song ( :Long press)
• SiriusXM mode – Station up-down/ Station
fast up-down – (Long press) / Move cursol
(direct mode)
• BT(A2DP) mode – Previous-next track /
Fast forward-reverse(long press)
• BT(HFP) mode – Select list (in CALL LIST)
/ Answer ( : incoming) / Terminal call(
Transfer call (During talking -> : press)
• Press the [ ] or [ ] button to tune in a
station for seek tuning or manual tuning
(Radio mode/Satellite mode only).
[ ], [ ] buttons
• RADIO mode – Preset station up/down
• USB mode – Select (in Folder search mode)
• iPod mode – Select (in Menu mode)
• AUX mode – No function
• PANDORA mode – Thumbs up(
Thumbs down( ) / Select Serch mode /
Select station(in Search mode)
• SiriusXM mode – Preset channel up-down
/ Category up-down(in Category mode) /
Numeric up-down(Direct mode)
• BT mode – Redail(Press
-> "ENT") /
Select CALL LIST(in Menu mode)
[MENU/BAND] button
• Each time the button is pressed, the band
switches in the following order:
Radio : FM1 -> FM2 -> FM3 -> AM ->
FM1.....
Sirius Satellite : SR1 -> SR2 -> SR3
• Press and hold the button to enter the
category selection mode. (in Sirius Satellite
mode.)
• Press and hold the button, it will start from
the first track. (in CD/MP3/WMA and USB
modes)
• Press the [MENU] button to enter the list
search mode. (in CD/MP3/WMA and USB
modes)
6
M502
[ ] button
• RADIO mode – Mute ON-OFF
• USB mode – Play-Pause
• iPod mode – Play-Pause
• AUX mode – No function
• PANDORA mode – Play-Pause
• SiriusXM mode – Instant replay mode /
Play/ Pause(in Instant replay mode)
) /
• BT(A2DP) mode – Play-Pause
• BT(HFP) mode – No function
IR-Receiver
• Receiver for optional IR remote control unit.
(Operating range: 30° in all directions)
) /

4. OPERATIONS

Basic Operations

Note:
• Refer to the diagrams in "3. CONTROLS"
when reading this chapter.
CAUTION
When the unit is turned on, starting and
stopping the engine with its volume raised
to the maximum level may harm your
hearings.
Be careful about adjusting the volume.
Power on / off
Notes:
• Start the engine before using this unit.
• Be careful about using this unit for a long
time without running the engine. If you drain
the car's battery too far, you may not be
able to start the engine and this can reduce
the service life of the battery.
1. Start the engine. The power button / knob
illumination on the unit will light up.
Engine ON
position
2. Press the [CONTROL] knob on the front
panel or [SRC / ] button on the remote
control to turn on the power under standby
mode. The unit goes back to the last status
after power on.
3. Press and hold the [CONTROL] knob
(center long press) on the front panel,
and rotate the [CONTROL] knob choose
POWER OFF, then press the [CONTROL]
knob on the front panel to turn off the power.
Or press and hold [SRC / ] button on
remote control to turn off the power.
Mute
Press the [MUTE] button on the remote control
to mute the volume from the unit.
Note:
Doing the operation above again or adjusting
volume will release muting.
Volume adjustment
Turn the [CONTROL] knob on the front panel.
The adjustable range of volume is 0 to 40.
CAUTION
While driving, keep the volume level at which
external sounds can be heard.
Playing source selection
Press [CONTROL] knob on the front panel
repeatedly to choose desired playing source.
Note:
• Playing source selection means selecting work
mode, such as RADIO mode and AUX mode,
etc.
Display system time
Press the [DISP] button on the remote control to
switch the display information, system time and
playing source.
RESET
If you have below problems, pls press [RESET]
button.
• Unit can not power on
• Nothing happens when buttons are pressed
• Display is not accurate
Note:
* When the [RESET] button is pressed, preset
radio stations, audio setting, etc..stored in
memory are kept.
RESET