Important Safety Instructions - Brother HL-2130 User Manual

Important safety instructions

1 Read all of these instructions.
2 Save these instructions for later reference.
3 Follow all warnings and instructions marked on the product.
4 Unplug this product from the wall socket before cleaning inside of the product. DO NOT use
liquid or aerosol cleaners. Use a dry, lint-free soft cloth for cleaning.
5 DO NOT place this product on an unstable cart, stand, or table. The product may fall, causing
serious damage to the product.
6 Slots and openings in the casing at the back or bottom are provided for ventilation. To ensure
reliable operation of the product and to protect it from overheating, these openings must not
be blocked or covered. The openings should never be blocked by placing the product on a bed,
sofa, rug, or other similar surface. This product should never be placed near or over a radiator
or heater. This product should never be placed in a built-in installation unless adequate
ventilation is provided.
7 This product should be connected to an AC power source within the range indicated on the
rating label. DO NOT connect it to a DC power source or inverter. If you are not sure, contact
a qualified electrician.
8 This product is equipped with a 3-wire grounded plug. This plug will only fit into a grounded
power outlet. This is a safety feature. If you are unable to insert the plug into the outlet, call
your electrician to replace your obsolete outlet. DO NOT defeat the purpose of the grounded
plug.
9 Use only the power cord supplied with this product.
10 DO NOT allow anything to rest on the power cord. DO NOT place this product where people
can walk on the cord.
11 Use the product in a well-ventilated area.
12 The power cord, including extensions, should be no longer than 16.5 feet (5 metres).
DO NOT share the same power circuit with other high powered appliances, such as an air
conditioner, copier, shredder, and so on.
13 DO NOT place anything in front of the product that will block printed pages or received faxes.
DO NOT place anything in the path of printed pages or received faxes.
14 Wait until pages have exited the product before picking them up.
15 Unplug this product from the power socket and refer all servicing to Brother Authorized Service
Personnel under the following conditions:
 When the power cord is damaged or frayed.
 If liquid has been spilled into the product.
 If the product has been exposed to rain or water.
 If the product does not operate normally when the operating instructions are followed.
Adjust only those controls that are covered by the operating instructions. Incorrect
adjustment of other controls may result in damage and will often require extensive work by
a qualified technician to restore the product to normal operation.
8
A