Section 1: Boat Stand Assembly; Section 2: Removing The Canopy; Section 3: Installing The Radio System Batteries - Pro Boat G26 Owner's Manual

There are 4 plywood boat stand pieces. The 2 short plywood
pieces are the ends of the boat stand.
Secure the 2 long plywood pieces of the interlocking boat stand to
one end of the short plywood pieces. Repeat with the remaining
short plywood pieces.
Secure the stand together where each piece is joined with epoxy
or CA glue (not included).
Unscrew the 2 knurled hatch-mounting screws from the rear of
the hatch. Slide the front hatch retainer toward the rear of the
boat and lift the hatch from the boat.

Section 3: Installing the Radio System Batteries

Receiver Batteries
Remove the 10 2.5mm hex head screws that secure the clear
Lexan radio box cover.
Remove the receiver battery holder and install 4 "AA" alkaline
batteries in the battery holder. Note proper polarity.

Section 1: Boat Stand Assembly

Section 2: Removing the Canopy

6