Section 14: Clutch; Section 15: Troubeshooting Guide - Pro Boat G26 Owner's Manual

The centrifugal clutch automatically engages when the engine rpm is
increased. Be sure that the idle speed adjustment is set low enough so
that the propeller does not rotate at idle.
Periodically disassemble the clutch and clean debris from the clutch
shoes and the inner clutch bell with DYN5505 Dynamite
Problem
Engine will not start Engine will not start
Engine starts, then dies Engine starts, then dies
Engine starts and runs for Engine starts and runs for
several minutes, then dies several minutes, then dies

Section 14: Clutch

Nitro Force.
®
Section 15: Troubleshooting Guide
Possible Solution
Improper needle setting: see Zenoah Improper needle setting: see
Out of fuel: fill fuel tank Out of fuel: fill fuel tank
Improper fuel: Improper fuel: use fresh Gasoline & Zenoah 2-Cycle Oil (mixed 32 parts gas to 1 part oil)
Bad Spark plug: replace Bad Spark plug: replace
Flooded engine: remove spark plug, invert boat and operate the pull-starter to Flooded engine: remove spark plug, invert boat and operate the pull-starter to
remove fuel remove fuel
Fuel line blocked or broken: connect or replace fuel line Fuel line blocked or broken: connect or replace fuel line
Reset needles to baseline setting: see Zenoah instructions Reset needles to baseline setting: see Zenoah instructions
Baseline settings for low and hi-speed needle valves is 1–1 Baseline settings for low and hi-speed needle valves is 1–1
Bad fuel: replace Bad fuel: replace
Improper needle settings: see Zenoah Engine Manual Improper needle settings: see Zenoah Engine Manual
Overheated engine: check for clogged or damaged cooling system Overheated engine: check for clogged or damaged cooling system
Debris in carburetor: remove, clean and replace
® Engine Manual
12
1 / turns out
4