Section 11: Stopping The Engine; Section 10: Starting The Engine - Pro Boat G26 Owner's Manual

Choking the Engine
Close the choke by rotating the small yellow tubing extension.
This is not necessary if the engine is warm.
NOTE: The engine is water-cooled. Refrain from running the engine without proper cooling water or engine damage will result. Carefully,
place the boat in the water as soon as possible after the engine has been started.
Idle the boat near shore and press the kill switch located through
the hole in the hatch as shown.
Section 10: Starting the Engine (cont.)

Section 11: Stopping the Engine

Pull-starting the Engine
With an assistant holding the boat to the boat stand and
bracing the engine with one hand, pull the starting cord briskly
several times. Once the engine fires (begins to start), open the
choke. Prolonged choking will flood the engine with fuel. See
Section 15: Troubleshooting Guide to correct the flooding
condition.
10