Typical Installation - Graco Delta Spray 308741N Instructions Manual

A
B
KEY
A Delta Spray Gun
See page 4 for gun part numbers.
B Fluid Inlet; 3/8 npsm (R3/8–19)
C Air Swivel Inlet; 1/4 npsm (R1/4–19)
D Air Hose
Recommend 5/16" (7.9 mm) ID hose
Optional 3/8" (9.5 mm) ID hose
E Air Shut-off Valve
F Air Regulator
G Air Filter
H Air Supply Line
The Delta Spray HVLP spray gun was designed to
produce the highest quality finish with today's fluids as
well as the Low V.O.C. (volatile organic compound)
fluids of tomorrow.
This spray gun can spray most coatings or finishes
currently being used for automotive, industrial, aero-
space, marine, wood, plastic and architectural applica-
tions, while easily operating from any paint delivery
system, including cups, pressure pots, or remote
pumps for production line operation.
The spray gun typically utilizes 40 psi (280 kPa, 2.8
bar) inbound air pressure to produce high quality paint
finishes at 10 psi (70 kPa, 0.7 bar) atomizing air pres-
sure.
The air regulator must have a minimum air flow
capacity of 30 scfm at 100 psi (0.7 MPa, 7 bar) air
pressure. Refer to the Pressure Drop Charts, page
11.

Typical Installation

C
E F
D
Ventilate the Spray Booth
WARNING
To prevent hazardous concentrations of
toxic and/or flammable vapors, spray
only in a properly ventilated spray booth.
Do not operate the spray gun unless
ventilation fans are operating.
Check and follow all of the National,
State and Local codes regarding air ex-
haust velocity requirements.
Check and follow all local safety and fire codes.
H
G
308741 7