Advertisement
PAINT
Caution: If flushing with water, do not leave water in sprayer. Flush again with mineral
spirits, oil or Pump Armor and leave this protective coating in the sprayer to help
prevent freezing or corrosion and increase sprayer life.
FLUSH
309410
13. Raise siphon tube above flushing fluid
FLUSH
14. Make sure plastic center tube is tightened
15. Wipe sprayer, hose and gun with a rag
16. Clean tip, guard and gasket with a soft
and run sprayer for 15 to 30 seconds to
drain fluid. Turn pump switch OFF. Turn
engine or motor OFF.
securely. Install filter bowl and filter. Hand
tighten filter bowl. Hand tighten gun han-
dle.
soaked in water or mineral spirits.
bristle brush to prevent part failure due
to dried materials. Assemble parts and
attach loosely onto gun.
Advertisement
