Toyota Camry Solara 2007 Operating Manual page 249

(c) Erasing the entire HomeLink
memory (all three programs)
To erase all previously programmed codes
at one time, press and hold down the 2
outside buttons for 20 seconds until the
indicator light flashes.
If you sell your vehicle, be sure to erase
the programs stored in the HomeLink
memory.
For additional programming assistance
R
with your HomeLink
Transceiver call the:
D
Toyota Customer Experience Center at
1−800−331−4331 (U.S.A.)
D
Toyota Canada Customer
Centre at 1−888−869−6828 (Canada)
R
Refer to HomeLink
WWW.HOMELINK.COM
CAUTION
D
When programming the HomeLink
Universal Transceiver, you may be
operating a garage door or other
R
device. Make sure people and ob-
jects are out of the way of the ga-
rage door or other device to pre-
Universal
vent potential harm or damage.
D
Do not use this HomeLink
sal Transceiver
door opener that lacks the safety
stop and reverse feature as re-
Interaction
quired by federal safety standards.
(This includes
opener model manufactured before
April 1, 1982.) A garage door open-
er which cannot detect an object
(signaling the door to stop and re-
verse), does not meet current feder-
al safety standards. Using a garage
door opener without these features
increases risk of serious injury or
death.
R
on the internet at:
This device complies with Part 15 of the
FCC Rules and with RSS−210 of the IC
Rules. Operation is subject to the fol-
lowing two conditions: (1) This device
R may not cause harmful interference, and
(2) this device must accept any interfer-
ence
that may cause undesired operation.
WARNING: This transmitter has been
tested and complies with FCC and IC
rules. Changes or modifications not
R
expressly approved by the party re-
Univer-
sponsible for compliance could void
with any garage
the user's authority to operate the
device.
any garage door
received, including interference
249