Toyota Camry Solara 2007 Operating Manual page 158

NOTICE
z Do not use liquid sealants for a flat
tire as tire pressure warning valve
and transmitter will be damaged.
z When the tires must be repaired or
replaced, have them repaired or re-
placed by the nearest Toyota dealer
or authorized tire dealer. The tire
pressure warning valves and trans-
mitters will be affected
installation or removal of tires.
158
by the
IF THE TIRE PRESSURE
LIGHT BLINKS (COMES
BLINKING FOR 1 MINUTE)...
If the tire pressure warning light blinks
(comes on after blinking for 1 minute)
when the ignition key is turned to the
"ON" position, the tire pressure warn-
ing system is not working properly.
The system will be disabled in the follow-
ing conditions:
(When the condition becomes normal, the
system will work properly.)
D
If tires not equipped with tire pressure
warning valves and transmitters are
used.
D
If the ID code on the tire pressure
warning valves and transmitters is not
registered.
D
If electronic devices or facilities using
similar radio
nearby.
D
If a radio set at similar frequencies is
in use in the vehicle.
D
If a window tint that affects the radio
wave signals is installed.
D
If there is a lot of snow or ice on the
vehicle, in particular around the wheels
or wheel housings.
WARNING
D
If non−genuine Toyota wheels are used.
ON AFTER
D
If tire chains are used.
D
If the spare tire (except compact spare
tire) is in a location subject to poor
radio wave signal reception.
D
If the tire inflation pressure is more
than 500 kPa (5 kgf/cm
psi) or more higher than the specified
level.
If the tire pressure warning light continues
to blink (comes on after blinking for 1
minute) when the ignition key is turned to
the "ON" position,
checked by your Toyota dealer.
wave frequencies are
2
or bar, 70
have the system