Table of Contents
Advertisement
S
ETUP
Lamp
You will need to install a lamp prior to the initial operation of the fixture. Two BRL 50w halogen lamps
are included. This lamp is used on both the 115V and 230V versions of the Duo Moons™
Warning!
When replacing the lamp, please wait 15 minutes after powering down to allow the
unit to cool down! Always disconnect from main power prior to lamp replacement.
Do not touch the envelope (glass area) of the
bulb with bare hands. If this happens, clean the
lamp with alcohol and wipe it with a lint free cloth
before installation.
L AM P I N ST ALL AT I O N
1)
Remove the two (S1) thumbscrews from the
lamp cover plate located on top of the
fixture.
2)
If replacing the lamp, remove old lamp first.
3)
Reach in and using a cloth or napkin hold
the bulb and pull out of the lamp socket
located inside the reflector.
4)
Replace with a new lamp.
5)
Replace lamp cover, align the screw holes
and fasten the thumbscrews.
Mounting
O RI E NT AT IO N
This fixture may be mounted in any position provided there is adequate room for ventilation.
RIG G ING
It is important never to obstruct the fan or vents pathway. Mount the
fixture using, a suitable "C" or "O" type clamp. Adjust the angle of the
fixture by loosening both knobs and tilting the fixture. After finding the
desired position, retighten both knobs.
When selecting installation location, take into consideration lamp
replacement access and routine maintenance.
Safety cables should always be used.
Never mount in places where the fixture will be exposed to rain, high humidity, extreme temperature
changes or restricted ventilation.
Note!
Clamps sold separately!
CH-160A User Manual
S1
Lamps exposed
5
Hanging Clamp
2005-12-08/17:20
Advertisement
Table of Contents
