Selecting The Radio Input Source; Tuning And Storing Radio Stations - Grundig RRCD 3720 DEC User Manual

RADIO MODE
Antennas
1 For FM reception (VHF), extend the telescopic »Antenna«.
Note:
If the FM signal is too strong, it is advisable to push in the telescopic antenna.
2 The radio has a built-in rod antenna for MW reception. Turn the device around to align
the antenna.

Selecting the radio input source

Press »FUNCTION« to select TUNER as the input source.
1
– The most recently selected station is activated (Last Station Memory).

Tuning and storing radio stations

Automatic station search
After the device has been connected to the mains for the first time, in FM radio mode, the
device searches for radio stations and saves them on up to 20 presets.
Press the »ON/OFF« button after switching on the device.
1
– Display: »FM«, the presets, the frequency in rapid run-through, »PROGRAM« flashes.
– The search has started. After the search has finished, you will hear the station stored at
preset 01.
Note:
By pressing and holding down »PROG./RAND.« in radio mode, the automatic station
search can be started again at any time. However, the existing presets will be deleted.
Automatic station search
Press »FUNCTION« to select the frequency band (FM or MW).
1
– Display: »FM TUNER« or »MW TUNER«.
Activate the station search by pressing »
2
to rapid run-through.
– The search stops when a station is found.
Manual station search
1 Press » 8 « or » 9
– The frequency changes in 50 kHz steps (FM) and 9 kHz steps (MW).
_________________________________________________
8
« briefly several times to move the frequency up in steps.
« or » « until the frequency display changes
9
35