Table of Contents
Advertisement
Installation Instructions
CABLE CONNECTIONS
Connecting the Signal Cable:
signal cable. Plug the signal cable's 15-pin connector into the
computer's VGA port and tighten the two screws on the cable
connector.
Connecting the Power Cord:
Adapter. Then plug the DC-jack power cable into DC-IN Inlet.
Caution: If the AC outlet is not grounded (with three holes), install the
proper grounding adapter (not supplied).
1.
DC-Jack Power Cable
3.
AC Power Cord
the LCD monitor comes with a built-in
Plug the AC-power cord into the External
Figure 1
Connecting Cables
2.
Signal Cable
9
Advertisement
Table of Contents
