Reset To Factory Defaults - THOMSON SPEEDTOUCH 510V4 User Manual

6.3 Reset to Factory Defaults

Resetting your
SpeedTouch™
Hardware reset
Software reset
E-DOC-CTC-20050429-0095 v1.0
You might consider a reset to factory defaults as described below.
Be aware that a reset to factory defaults will revoke all configurational
!
changes you made to the SpeedTouch™.
You can choose between:
Hardware reset
Software reset
A reset to factory default settings deletes the configuration profile settings.
Therefore, after the reset, a reconfiguration of your SpeedTouch™ will be needed.
Proceed as follows:
Make sure the SpeedTouch™ is powered on.
1
Power off the SpeedTouch™ by pressing the power button until all LEDs turn
2
off.
Press the power button once again (shortly).
3
As soon as the Power/System LED is flashing green, press the power button
4
once more (shortly).
The Power/System LED stops flashing to become solid green. After six
5
seconds, it starts flashing green again. Press the power button once more
(shortly).
All LEDs flash green once.
6
The SpeedTouch™ reboots and will come online with factory default settings.
7
Proceed as follows:
Go to the SpeedTouch™ web pages.
1
In the menu select SpeedTouch > Configuration.
2
In the Pick a task... list, click Reset my SpeedTouch to default settings.
3
The SpeedTouch™ restarts.
4
The SpeedTouch™ returns to the SpeedTouch™ Home page (unless the IP
5
address of your computer is not in the same subnet as the default IP address of
the SpeedTouch™, being 192.168.1.254).
Chapter 6
Troubleshooting
85