Speaker Connector Installation; Hardware Reset Switch Connector Installation; Power Led Connector Installation; Ide & Atapi Device Installation - Gigabyte 6WXM User Manual

Pentium ii / iii / celeron processor mainboard

Table of Contents

6WXM

internal battery is 5 years, the user can change a new Battery to replace old

one after it cannot work.

M Danger of explosion if battery is incorrectly replaced.

M Replace only with the same or equivalent type recommended by the

manufacturer.

M Dispose of used batteries according to the manufacturer' s instructions.

3.7. SPEAKER CONNECTOR INSTALLATION

There is a speaker in AT system for sound purpose. The 4 - Pins connector

SPKR is used to connect speaker.

The RESET switch on panel provides users with HARDWARE RESET

function. The system will do a cold start after the RESET switch is pushed

and released by user. The RESET switch is a 2 PIN connector and should be

installed to RST on main board.

System has power LED lamp on the panel of chassis. The power LED will

light on off or flash to indicate which step on the system. The connector

should be connected to P+P-P- of main board in a correct direction.

3.10. IDE & ATAPI DEVICE INSTALLATION

There are two-Enhanced PCI IDE ports (IDE1, IDE2) on board, which

following ATAPI standard SPEC. Each IDE port can connected to two ATAPI

devices (IDE Hard Disk, CD-ROM or Tape Driver), so total four ATAPI

devices can exist in a system. The HD is the active LED port for ATAPI

devices.

After the I/O device installation and jumpers setup, the main board can be

mounted into the chassis and fixed by screw. To complete the main board

installation, the peripheral device could be installed now. The basic system

needs a display interface card. If the PCI - Bus device is to be installed in the

system, any one of three PCI - Bus slots can be used.

3.12. KEYBOARD & PS/2 MOUSE INSTALLATION

The main board supports PS/2 Mouse. The BIOS will auto detect whether the

PS/2 Mouse is installed or not & assign IRQ12 for PS/2 Mouse port if it is

installed. After installing the peripheral device, the user should check

3-9

Table of Contents