Auto-Check Control - Audi A5 Owner's Manual

document_0900452a8179700c.book Seite 29 Donnerstag, 22. März 2007 10:19 10
Clearing speed limit
– Drive the vehicle at a minimum of 5 km/h.
– Press the SET button for at least 2 seconds.

The speed warning symbol lights up briefly in the display to
confirm that the selected speed has been stored. The speed limit
that has been set remains stored until another speed is set with a
brief push of the button, or until the memory is cleared with a long
push of the button.
When the speed limit has been cleared, the display will show a

crossed-out warning symbol .
Applies to vehicles: with speed warning function
Setting speed limit warning 2
You can use the MMI* or sound system control console to
set, alter or cancel speed limit warning 2.
– Select: Function selector button
cluster > Speed warning.
Speed warning on/off - to activate or deactivate the speed
warning function ⇒ fig. 23.
Controls
will sound.
Speed limit warning 2 can be adjusted in increments of 10 km/h
between 30 and 240 km/h.

Auto-check control

Introduction
The auto-check control checks important components and vehicle
systems. These background checks are run constantly, as long as
the ignition is switched on.
A message is displayed in the instrument cluster if a fault should
occur or if any maintenance or repairs are urgently required. This is
accompanied by an audible warning signal. Depending on the
priority of the fault, a red or yellow warning symbol lights up in the
display.
The red symbols indicate a serious malfunction, whereas the yellow
ones represent other malfunctions or items requiring attention.
Additional messages to assist the driver may be shown with the red
or yellow symbols.
Automatic gearbox* function test
The auto-check control automatically checks the vehicle systems
when the ignition is switched on. If the selector lever is in position
Fig. 23 MMI display:
P or N, the following instruction will appear:
Setting speed limit
warning 2
When a gear (R, D etc.) is selected, this message disappears and the
> Instrument
CAR
auto-check control function is displayed.
The driver message will disappear 30 seconds after switching on
the ignition or earlier, if there are other driver messages or malfunc-
tions.
Safety Driving tips General maintenance
Driver information system
Speed warning - to set the speed above which a warning signal
When stationary apply footbrake while selecting gear
Self-help
29
Technical data