All Reset - Citizen C500 Instruction Manual

• Changeover cannot be performed from the diving mode [Ready display]
or [0 m Reading after Depth Measurement] to the time/calendar mode.
• In case the depth reading is one meter or more, though the watch is
used on land
In this case, all reset should be performed by referring to page 49. If the watch
display is changed to the pre-state of the diving mode [Ready display] or to the
time/calendar mode when the crown is pulled out, there is no problem.
If the mode change cannot be made, all reset should be performed (see page
49). (Note 1)
• Digital display malfunction
Should strong impact or static electricity be applied to the watch by accident,
the digital display may malfunction at times. If this occurs, all reset should be
performed by referring to page 49. (Note 1)
• After battery replacement
After the battery is replaced, be sure to perform all reset by referring to page
49. If not done so, the watch does not operate properly, making correct
displays. (Note 1)
* Note 1
All reset operation will erase all the stored data.
48
M. ALL RESET
DIV
MAX
A SP
P
SEL CA
SEL SET
RES STP
1. Pull the crown out.
2. Press all three buttons together and
release.
3. Push the crown in to its normal position.
If the alarm sounds 2 times, all reset is
completed.
Because all the stored data are erased
after all reset, setting for each mode
should be performed again correctly.
49