Advertisement
4. Setting the Time and Calendar
Please note: An all reset is required if the watch displays a malfunction or
after a battery change. Please refer to the All Reset procedure, before setting
the time and calendar
1) When button A is pressed for at least 2 seconds during the time or
calendar display, the watch changes to the seconds correction mode
(seconds flash).
2) Set the seconds by pressing button M.
* When button M is pressed when the seconds are between 30 and 59
seconds to reset the seconds to zero, the minutes are advanced by one
minute
3) Each time button B is pressed in the correction mode, the area of the
display that can be set changes according to the sequences shown below.
Press button B until the area of the display desired to be set flashes.
4) Press button M to set the flashing area of the display to the desired value.
*Pressing button M continiously causes the display to advance rapidly.
Time Display (TME)
5. All Reset Procedure
Perform the all-reset procedure described below after replacing the battery or
when the watch does not operate properly or the display has become
abnormal (no display or display remains on without going out) as a result of
being subjected to strong impact.
1. Press buttons A, B and M simultaneously for at least 4 seconds.
*All segments of the display will be lit during the time until the next
button is pressed after the buttons are released. (If another button
is not pressed after the buttons are released, all segments will be lit
for about 60 seconds.)
*When any button is pressed when all display segments are lit, the
watch will display the graphic display after displaying 12:00 (AM)
indicating that the all- reset procedure has been completed.
2. After the all-reset procedure is completed, make sure to reset each
mode to the correct setting before using the watch.
Calendar Display (CAL)
Seconds
Minutes
Year
Date
Hours
Month
Advertisement
