Table of Contents
Advertisement
A washing program can be selected first, and
then the pre−selected start time can be pro−
grammed, or vice versa.
If a pre−selected start time is programmed without a
washing program, the programmed time goes out after
5 seconds. After selecting a program, the selection of
the start delay must take place within 5 seconds.
An activated pre−selected start time will be indicated
in the display field by a blinking dot.
After the pre−selected start time has expired, the
machine starts up the selected program automati−
cally.
Correcting or Deleting the
Program Selection / Pre−se−
lected Start Time
Using the Stop button, a running program or the pre−
selected start time can be interrupted or cancelled.
Interruption:
− Briefly activating the Stop button causes an inter−
ruption of all programs, and the Stop control lamp
blinks.
− Activating the Stop button again makes the pro−
gramming active once again.
Cancelling:
− Holding down the Stop button longer than 2 se−
conds deletes the program and the pre−selected
start time, and any water present will be pumped
out. The Program End symbol in the display lights up
as soon as all the water has been pumped out.
ECO button
The wash temperature is reduced using the ECO button,
as a result less energy is consumed during heating up.
The economy button can be selected for all wash pro−
grams.
The ECO button should be used in particular when
using low−alkali compact cleaners with enzymes. The
enzymes produce their full dirt−releasing effect in a
temperature range between 40 and 50 °C.
Using the Half Load button, energy is saved if the dish−
washer is only half full. Nevertheless optimal washing
results are achieved (see Program Chart).
In the case of the simultaneous selection of
ECO and Half Load, the Half Load program is
run.
Half load
Mains switch
Economy
17
Hide quick links:
Advertisement
Table of Contents
