Table of Contents
Advertisement
Wiring installation:
Penetrate the wall with a 30-35 mm hole at the controller location.
1.
Install the supplied cable between the location of the controller and the water heater.
2.
3.
Remove the base plate from the controller.
4.
Peel off one side of the adhesive paper from the foam packing and adhere to the back face of the base
plate. This is the side without the projections.
5.
Peel off the remaining adhesive paper from the foam packing.
Draw the cable through the central hole in the base plate.
6.
Fix the base plate to the wall using suitable screws and wall anchors.
7.
Ensure the projections in the base plate are pointing upwards.
Plug the controller wire into the Bathroom controller cable.
8.
Place the controller over the base plate.
9.
Ensure the projections in the base plate fit into the housings in the controller.
10.
Fix the controller to the base plate at the bottom of the controller, using the screw provided.
"Connecting the Controller(s) to the Water Heater"
Proceed to
11.
controller
controller
screw
projections
cable
cable connectors
Bathroom Controller (Standard and Deluxe) Installation
INSTALLATION – CONTROLLERS
on page 68.
adhesive paper
screws
base plate
67
suitable wall
anchors
wall
penetration
foam packing
Hide quick links:
Advertisement
Table of Contents
