Wiring Installation; Kitchen Controller (Standard And Deluxe) Installation Concealed Cable - Rheem 18 Owner's Manual & Installation Instructions

INSTALLATION – CONTROLLERS

Wiring installation:

Penetrate the wall with a 30-35 mm hole at the controller location.
1.
Install the Kitchen controller cable between the location of the controller and the water heater.
2.
3. Remove the base plate from the controller.
4. Draw the cable through the central hole in the base plate.
Fix the base plate to the wall using suitable screws and wall anchors.
5.
Ensure the projections in the base plate are pointing upwards.
6. Connect the cable to the two terminals on the back of the controller (connections are not polarity
sensitive).
Ensure the connecting screws are seated tightly.
Place the controller over the base plate.
7.
Ensure the projections in the base plate fit into the housings in the controller.
8. Fix the controller to the base plate at the bottom of the controller, using the controller screw provided.
"Connecting the Controller(s) to the Water Heater"
9. Proceed to
controller
controller screw
cable
terminal
screws
Kitchen Controller (Standard and Deluxe) Installation
Concealed Cable
on page 68.
suitable wall
anchors
screws
base plate
64
wall
penetration
projections