SIS AC97 AUDIO (Enabled)
This option allows you to control the onboard AC97 audio. Disable this item if
you are going to install a PCI audio add-on card.
SIS S/W Modem (Enabled)
This option allows you to control the onboard S/W modem. Disable this item if
you are going to install an external modem.
SIS 1394 Controller (Enabled)
This option allows you to control the onboard 1394 controller.
Press <Esc> to return to the Integrated Peripherals screen.
Onboard SuperIO Device
Scroll to this item and press <Enter> to view the following screen:
Phoenix – AwardBIOS CMOS Setup Utility
Onboard FDC Controller
Onboard Serial Port 1
Onboard Serial Port 2
UART Mode Select
UR2 Duplex Mode
Onboard Parallel Port
Parallel Port Mode
ECP Mode Use DMA
↑ ↓ → ← : Move
Enter: Select
F5:Previous Values
Onboard FDC Controller (Enabled)
This option enables the onboard floppy disk drive controller.
Onboard Serial Port 1 (3F8/IRQ4)
This option is used to assign the I/O address and interrupt request (IRQ) for
onboard serial port 1 (COM1).
Onboard Serial Port 2 (2F8/IRQ3)
This option is used to assign the I/O address and interrupt request (IRQ) for
onboard serial port 2 (COM2).
UART Mode Select (Normal)
This field is available if the Onboard Serial Port 2 field is set to any option but
Disabled. UART Mode Select enables you to select the infrared communica-
tion protocol-Normal (default), IrDA, or ASKIR. IrDA is an infrared
communication protocol with a maximum baud rate up to 115.2K bps. ASKIR
is Sharp's infrared communication protocol with a maximum baud rate up to
57.6K bps.
Onboard SuperIO Device
[Enabled]
[3F8/IRQ4]
[2F8/IRQ3]
[Normal]
[Half]
[378/IRQ7]
[ECP]
[3]
+/-/PU/PD: Value:
F10: Save ESC: Exit
F6:Fail-Safe Defaults
39
Item Help
Menu Level
F1:General Help
F7:Optimized Defaults