Table of Contents
Advertisement
of the display for a few seconds and the
integrated red light of button 8 start flash-
ing.
• End of programme
When the programme has finished three
flashing zeros are displayed, the pilot light
9 and the pilot light of button 8 go out
and the door can be opened.
7.2: Washing programme phase icons
• Wash
• Rinses
• Drain
• Spin
By selecting the wash programme, the pro-
gramme phase icons corresponding to the
various phases making up the programme
are shown in the bottom part of the display.
After having pressed button 8 only the icon
of the running phase stays on.
FIRST USE
• Ensure that the electrical and water
connections comply with the installa-
tion instructions.
• Remove the polystyrene block and
any material from the drum.
• Pour 2 litres of water into the main
wash compartment
gent drawer in order to activate the
PERSONALISATION
Acoustic signals
The machine is provided with an acoustic
device, which sounds in the following cases:
• at the end of the cycle
• if there is a fault.
By pressing the 4 and 5 buttons simultane-
ously for about 6 seconds , the acoustic
signal is deactivated (except if there is a
fault). By pressing these 2 buttons again,
the acoustic signal is reactivated.
Child safety lock
This device permits you to leave the appli-
ance unattended and not to worry that chil-
dren might be injured by or cause damage
DAILY USE
Load the laundry
Open the door by carefully pulling the door
handle outwards. Place the laundry in the
7.3: Heating phase
During the washing cycle the display shows
a temperature icon indicating that the appli-
ance has started the heating phase of the
water in the tub.
7.4: Soil degree icons
When selecting a programme on the dis-
play appears an icon indicating the degree
of soiling automatically proposed by the ma-
chine:
• Intensive
• Normal/Daily
• Light/Quick
• Super Quick
7.5: Child safety lock
This device permits you to leave the appli-
ance unattended during it's functioning.
of the deter-
to the appliance. This function remains ena-
bled also when the washing machine is not
working.
There are two different ways to set this op-
tion:
1. Before pressing button 8 : it will be im-
2. After pressing button 8 : it will be impos-
To enable or disable this option press simul-
taneously for about 6 seconds buttons 5
and 6 until on the display, the icon
pears or disappears.
drum, one item at a time, shaking them out
as much as possible. Close the door.
ECO valve. Then run a cotton cycle
at the highest temperature without
any laundry in the machine, to re-
move any manufacturing residue
from the drum and tub. Pour 1/2 a
measure of detergent into the main
wash compartment and start the ma-
chine.
possible to start the machine.
sible to change any other programme or
option.
electrolux 7
ap-
Advertisement
Table of Contents
