2 electrolux Electrolux. Thinking of you. Share more of our thinking at www.electrolux.com CONTENTS Safety information Care and cleaning Product description What to do if... Control panel Technical data First use Consumption values Personalisation Installation Daily use Electrical connection Helpful hints and tips...
Page 3
3 • When unpacking the appliance, check • Never pull the power supply cable to re- that it is not damaged. If in doubt, do not move the plug from the socket; always use it and contact the Service Centre.
4 electrolux PRODUCT DESCRIPTION Your new appliance meets all modern requirements for effective treatment of laundry with low water, energy and detergent consumption. Its new washing system allows to- tal use of detergent and reduces water consumption so saving energy.
5 Flap for powder or liquid deter- gent (see "Flap for powder or liquid deter- gent" in the chapter "Daily use" for more details). CONTROL PANEL Below is a picture of the control panel. It shows the programme selector dial as well as the buttons, pilot light and the display.
Page 6
6 electrolux fabrics from creasing. Before opening the 1 hour up to a maximum of 20 hours by door it will be necessary to empty out the means of this button. water. To empty out the water, please read Avvio/Pausa the paragraph «At the end of the pro-...
7 of the display for a few seconds and the 7.3: Heating phase integrated red light of button 8 start flash- During the washing cycle the display shows ing. a temperature icon indicating that the appli- • End of programme...
Page 8
8 electrolux Measure out the detergent and the fab- ric softener Flap for powder or liquid detergent Pull out the dispenser drawer until it stops. UP- The flap position if using POWDER Measure out the amount of detergent re- detergent...
Page 9
9 • Measure out the detergent. • Pour the powder detergent into the main If the flap is not in the desired position: wash compartment • Pull out the dispenser drawer until it stops. • Remove the remaining powder form The flap is down and you wish to use the flap.
Page 10
10 electrolux • Do not use liquid detergent if the washing programme doesn't start im- mediately. In these cases, use the flap in "UP" po- sition . Select the required programme by turning the programme selector dial (1) Turn the programme selector dial to the re- quired programme.
Page 11
11 Select the available option by pressing Start the programme by pressing buttons 3, 4 and 5 button 8 Depending on the selected programme, dif- To start the selected programme, press the ferent functions can be combined before button 8 , the green pilot light of the button pressing the button 8 .
Page 12
12 electrolux Important! The Time Manager cannot be You can select now a new programme. selected with the Economy programmes. Opening the door The availability of these soil level icons After the programme has started (or during change according to the type of fabric as the delay time) the door is locked, if you shown in the following chart.
13 Stand by : once the programme has finish- display is reduced. By pressing any button ed after a few minutes the energy saving sys- the appliance will come out of the energy tem will be enabled. The brightness of the saving status.
14 electrolux Grass: soap lightly and treat with bleach for all types of fabric, or special for wool- lens only. (whites and fast coloureds only). Ball point pen and glue: moisten with ace- The detergent and any additives must be...
Page 15
15 Programme - Maximum and Minimum Temperature Detergent Cycle Description - Maximum Spin Speed - Maxi- Options Compartment mum Fabrics Load - Type of Laundry SINTETICI SPIN 60° - Cold ANTIPIEGA Main wash - Rinses PREWASH Maximum spin speed: 800 rpm EXTRA RINSE Max.
Page 16
16 electrolux Programme - Maximum and Minimum Temperature Detergent Cycle Description - Maximum Spin Speed - Maxi- Options Compartment mum Fabrics Load - Type of Laundry LINGERIE SPIN 40° - Cold ANTIPIEGA Main wash - Rinses Maximum spin speed: 800 rpm Max.
17 Programme - Maximum and Minimum Temperature Detergent Cycle Description - Maximum Spin Speed - Maxi- Options Compartment mum Fabrics Load - Type of Laundry O = OFF For cancelling the programme which is running or to switch the machine off .
Page 18
18 electrolux Door seal Check from time to time the door seal and eliminate eventual possible objects that could be trapped in the fold. Clean the chamber of dispenser drawer Drain pump with a brush. The pump should be inspected regularly and particularly if: •...
Page 19
19 8. Check carefully whether the pump im- 4. Place a container close to the pump to peller rotates (it rotates jerkily). If it collect any spillage. doesn’t rotate, please contact your 5. Pull out the emergency emptying hose, Service Centre.
Page 20
20 electrolux 11. Close the pump door. 4. Screw the hose back onto the tap. 5. Unscrew the hose from the machine. Keep a rug nearby because some water may flow. 6. Clean the filter in the valve with a stiff brush or with the piece of cloth.
21 on the hose. Empty the bowl. Repeat 3. screw the water inlet hose back on and the procedure until water stops flowing reposition the emergency emptying out; hose after having put the cap on again. 6. clean the pump if necessary as previous- By doing this, any water remaining in the ma- ly described;...
Page 22
22 electrolux Problem Possible cause/Solution The water tap is closed. E10 • Open the water tap. The inlet hose is squashed or kinked. E10 • Check the inlet hose connection. The machine does not fill: The filter in the inlet hose is blocked. E10 •...
23 Problem Possible cause/Solution The electronic unbalance detection device has cut in because the laundry is not evenly distributed in the drum. The laundry is redis- tributed by reverse rotation of the drum. This may happen several times before the unbalance disappears and normal spinning can re- sume.
24 electrolux CONSUMPTION VALUES Programme Energy consumption Water consumption Programme duration (KWh) (litres) (Minutes) COTONI 90° 2.15 COTONI 60° 1.40 CICLO DI RISPARMIO 1.19 For the duration of the programmes, ENERGIA 60° please refer to the COTONI 40° 0.75 display on the con- trol panel.
Page 25
25 4. Slide out the relevant plastic spacers. 6. Fill the smaller upper hole and the two large ones with the corresponding plas- tic plug caps supplied in the bag contain- ing the instruction booklet. 5. Open the porthole and remove the poly- styrene block fitted on the door seal.
Page 26
26 electrolux noise and displacement of the machine dur- ing operation. Caution! Never place cardboard, wood or similar materials under the machine to compensate for any unevenness in the floor. 3. Set the hose correctly by loosening the ring nut. After positioning the inlet hose, be sure to tighten the ring nut again to prevent leaks.
27 Water drainage The end of the drain hose can be posi- tioned in three ways. • Hooked over the edge of a sink using • In a sink drain pipe branch. This the plastic hose guide supplied with the branch must be above the trap so that machine.
28 electrolux The manufacturer does not accept Should the appliance power supply any responsibility for damage or cable need to be replaced, this injury through failure to comply must be carried out by a Service with the above safety precaution.