Operation - Dometic 8900 Series Operation Manual

SeaLand MasterFlush Toilet
6.3 Changing flush modes
MasterFlush toilets offer two flush settings to help manage water consumption:
Normal flush – Uses 0 .85 gal . (3 .2 liters) per flush . Adds water to bowl after every flush .
Dry Bowl flush – Uses 0 .45 gal . (1 .7 liters) per flush . Does not add water to bowl after flush .
To change from Normal to Dry Bowl flush setting, press "Flush" switch for about five seconds . When
"Power On" light (fig .
changed to Dry Bowl setting . Change mode to Normal flush by following the same procedure .
6.4 Indicator lights
"POWER ON" INDICATOR
On the Dometic flush switch panel, a steady green "Power On" light (fig .
electrical power to the toilet is activated . A momentary flashing green light indicates when flush
mode is changing .
"FULL TANK" INDICATOR
The Dometic flush switch panel includes a red "Full Tank" light (fig .
holding tank is full and should be pumped out . When the red light is illuminated, electrical power to the
toilet automatically shuts off to prevent possible overfilling of the holding tank .
6.5 Bidet operation
(toilet models with
integrated bidet only)
1 . Turn on bidet faucet by
turning handle away from
toilet (fig . 4 ) .
2 . Adjust water temperature by
turning handle up for warm
water and down for cool
water (fig . 5 ) .
3 . Use electronic "Flush" switch
to clear toilet bowl during
and after bidet use .
Caution! Hazard of Flooding
Be sure to shut bidet faucet off completely after use .
3
3, p . 6) begins flashing, release "Flush" switch . Flush mode has been
4
3 3, p . 6) indicates when
3 4, p . 6) to indicate when the
5

Operation

7