Operation - Dometic 8900 Series Operation Manual

Specifications
6

Operation

6.1 Toilet system start-up
1 . Turn on water supply to toilet .
2 . Press "Flush" switch (fig .
and run for about six seconds to clear bowl . It will take about five seconds to refill bowl .
3 . Toss several sheets of toilet paper into bowl and repeat
cycle . The bowl should completely clear .
6.2 Normal toilet operation
ADDING WATER TO TOILET BOWL
Press "Add Water" switch (fig .
is achieved . (Water flow will shut off automatically if switch
is pressed too long to avoid overflow .) More water is usually
added only when flushing solids .
FLUSHING TOILET
Press "Flush" switch (fig .
siphons water and waste from the bowl, macerates, and propels the effluent through the discharge
line to the holding tank .
Note
If toilet system is equipped with Vimar or Gewiss
flush switches and indicator lights supplied by
Dometic, flush control and indicator light graphics
are the same as those on the Dometic flush panel .
Caution – Do Not Flush Foreign Objects!
Flush only water, bodily wastes and rapid-dissolving toilet
tissue . Do not flush wet wipes, sanitary napkins, condoms,
diapers, paper cups, cotton swabs, food, hair or liquids
such as oils or solvents as clogging or damage to the toilet
or toilet system may occur .
Note
Make sure all guests understand toilet operation before use .
6
3 2) once . After nine seconds of water flow, macerator pump will start
3 1) until desired water level
3 2) down, then release it . This activates a powerful macerator pump that
SeaLand MasterFlush Toilet
3
1
3
Dometic flush switch/status panel
1
2
Vimar or Gewiss flush switch/
status panel (optional)
2
4
3
4