Operation - Dometic 8700 Series MasterFlush Operation Manual

Dometic 8700 Series MasterFlush Toilet
6

Operation

6.1 Toilet system start-up
1. Turn on water supply to toilet.
and run for about six seconds to clear bowl. It will take about five seconds to refill bowl.
3. Toss several sheets of toilet paper into bowl and repeat
cycle. The bowl should completely clear.
6.2.1 Normal toilet operation -
Dometic touchpad or other wall switch
ADDING WATER TO TOILET BOWL
FLUSHING TOILET
macerator pump that siphons water and waste from the bowl, macer-
tank.
Caution – Do Not Flush Foreign Objects!
Flush only water, bodily wastes and rapid-dissolving toilet
such as oils or solvents as clogging or damage to the toilet
or toilet system may occur.
Note
Make sure all guests understand toilet operation before use.
6.2.2 Changing flush modes
Normal flush
Dry Bowl flush
6.2.3 Indicator lights
"POWER ON" INDICATOR
mode is changing.
"FULL TANK" INDICATOR
tank is full (if connected to a tank monitoring system) and should be pumped out. When the red light is
illuminated, electrical power to the toilet automatically shuts off to prevent overfill of the holding tank.
4
4 1) until desired water level
4
2), then release it. This activates a powerful
4
4
1
3
4 3) indicates when
4
4) to indicate when the holding
Operation
2
4
7