Ducati SUPERBIKE 1098 Tricolore Use And Maintenance Manual page 48

To adjust the position of the rear brake pedal, proceed as
6 7
follows:
Loosen the locknut (4).
Turn the pedal travel adjustment bolt (5) until the pedal is in
the desired position.
Tighten the locknut (4) to a torque of 2.3 Nm.
Operate the pedal by hand to check that there is 1.5 to 2 mm
of freeplay before the brake bites.
E
If not, adjust the length of the master cylinder pushrod as
follows.
Slacken off the locknut (6) on the pushrod.
Screw the rod into the clevis (7) to increase play, or unscrew
it to reduce play.
4
Tighten the lock nut (6) to a torque of 7.5 Nm and re-check
the free play.
5
fig. 36
48