Table of Contents
Advertisement
When you switch the LAP function off using the menu,
the lap in progress is not saved.
If the LAP function is active and the display is suddenly
switched off (Key-Off), the LAP function is switched off
automatically (even if the timer was ON, the lap in progress
is not saved).
If the timer is not stopped, when it reaches 99 minutes,
59 seconds and 99 hundredths, it restarts from 0 (zero)
and continues until the function is switched off.
If, however, the LAP function is switched on and the
memory has not been cleared, but fewer than 30 laps
have been saved (e.g. 18 laps), the display will save any
remaining laps until the memory is saturated (in this case,
it will save a further 12 laps).
In this function, lap time only is displayed, but other data are
also saved (MAX speed, MAX rpm, rev limiter if reached) for
viewing at a later date in the Lap Memory function.
Press C
after 10 sec.
Press C
after 10 sec.
E
fig. 19
25
Advertisement
Table of Contents
